To avoid scratching the lamps, do not use a dry paper towel, chemical solvents or abrasive cleaners. Operation is the same, but some functions are different. Rugged Ridge acquired the exclusive rights to this hub and is the only supplier to the aftermarket industry. All of Chilton's online content for the 2000 Ford Ranger is updated monthly, so you'll have the most recent information on hand for any Do-It-Yourself project. Unless serviced, the system may not function properly in the event of a collision.
Put the truck in reverse to ensure disengagement, and then slowly creep forward. Infant: An infant less than 1 year old must ride in the front seat because: my vehicle has no rear seat; the rear seat in my vehicle cannot accommodate a rear-facing infant seat;. I lightly covered the hub internals with 5-20 Motor Oil to prevent corrosion and ensure proper hub to axle engagement. If the fuel filler cap is venting vapor or if you hear a hissing sound, wait until it stops before completely removing the fuel filler cap. Transmission fluid dipstick automatic transmission 4. Salt-spray tested epoxi enamel finish. Check the appropriate fuses before replacing any electrical components.
Is the resistance less than 5 ohms? Trip odometer Registers the kilometers miles of individual journeys. Release the clutch slowly while pressing gradually down on the accelerator pedal. Selecting 1 Low at higher speeds causes the transmission to shift to a lower gear, and will shift to 1 Low after vehicle decelerates to the proper speed. Is the resistance between 340 and 380 ohms? High fluid level Fluid levels above the safe range may result in transmission failure. Recognized unanimously as The Tough Hub by many thousand satisfied Ranger owners worldwide. Recycled engine coolant Ford Motor Company recommends the use of a recycled engine coolant produced by Ford-approved processes.
Windshield washer fluid reservoir 3. Ensure the correct automatic transmission fluid is used. Mode selector control Controls the direction of the airflow to the inside of the vehicle. These standards and guidelines can be obtained from Ford Motor Company. There are enough differences that you should read this manual. Make sure the gearshift is in P Park.
Fuel economy may decrease with lower temperatures during the first 12—16 km 8—10 miles of driving. Working with the engine on Automatic transmission: 1. If starting a vehicle with an automatic transmission: Make sure the parking brake is set. Never use strong detergents or soap. Always replace a fuse with one that has the specified amperage rating. Check the tire pressure when tires are cold, after the vehicle has been parked for at least one hour or has been driven less than 5 km 3 miles. Anytime that the media is changed, new radio station, etc.
See your dealer or a qualified service technician. Step 8: Our new hublock is on and ready to roll. Odometer Registers the total kilometers miles of the vehicle. To remove the brakelamp assembly: 1. Average rating for this file: 4. Check to make sure the locking mechanism functions properly.
The air conditioning compressor will operate in all modes except. The first track of the disc will begin playing. For additional information about the gearshift lever and the transmission control switch operation refer to the Automatic Transmission Operation section of the Driving chapter. Releasing the accelerator pedal will return your vehicle to the previously programmed set speed. Add enough fluid through the filler opening so that the fluid level is at the bottom of the opening. Ford may change the contents without notice and without incurring obligation. Failure B1315 Battery Saver Relay Coil Circuit.
A child age 1 to 12 must ride in the front seat because: the vehicle has no rear seat;. Internal components: Precision machined, heat treated. Ford cannot assume responsibility for any adverse effects or damage that may result from the use of such equipment. Make sure the vehicle is on level ground. Apply the accelerator slowly and steadily when starting from a full stop.
. If the air bag is deployed, the air bag will not function again and must be replaced immediately. Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company. The engine block heater is available as a Ford option and can also be obtained from your Ford dealer. Refer to the Capacities and specifications chapter.
Engine oil filler cap 4. Ensure that the cables are clear of fan blades, belts, moving parts of both engines, or any fuel delivery system parts. Set the parking brake and ensure the gearshift is securely latched in P Park. This guide is based upon my experience with my truck. After you have traveled 80 km 50 miles , thoroughly check your hitch, electrical connections and trailer wheel lug nuts. Ford recommends that all safety belt assemblies used in vehicles involved in a collision be replaced.