Which wires should I connect to which terminals on the 44160. The connectors on the white rodgers should have markings. Posted on Jan 28, 2009 The Yellow wire is for cooling, the white is for heating, the red is for power, the green is for blower fan, the blue is your common wire, all you should have to do is color code the wires to the thermostat. Remove the wall plate from the new thermostat by pressing the release tab on the bottom of the thermostat. To create custom programs, see pages 34-37. Press the thermostat onto the wall plate and press to snap the bottom tab into place.
By using the pre-programmed settings, this thermostat can save you money by optimizing energy usage in heating and cooling. Loosen, but do not remove, the terminal screws. Manual operation instructions are on pages 28-31. The wiring your describing on the old thermostat is telling me you have a heat pump with second stage heat and the new thermostat is for air conditioning only. Under one of the panels there will be a control board to which the thermostat wires connect and this might have the letters printed on it.
Posted on Jul 13, 2008 Good morning Yakup. There may be as much as a 4-minute delay before the system turns on or off to protect the compressor. Tap the plastic anchors into the holes until they are flush with the wall. The wires must be labeled prior to removal to ensure proper reconnection. After wiring there is some programing to do to set up your new thermostat to your type of system. If that's not available, the only way to determine for certain where each wire goes, is to check what the installer did at the terminals in your home comfort system. The new one doesn't have second stage heat.
You will know it is wrong when you turn on the system in cooling mode and it blows hot or warm air. The furnace could be turned on by connecting R, W, and G together, I suppose, if the above doesn't work. Remove the existing thermostat cover to access the wires from the wall. Sep 04, 2011 The old thermostat has a second stage heat which is W2. Which wires should I connect to which terminals on the 44155. Your new Hunter thermostat will provide years of reliable service and year-round energy savings. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Hunter Fan Thermostat 44155C.
You can change the format to 24 hour format by pressing Program. The auto fan feature will not operate properly. The span setting can be adjusted if your system is cycling too fast or too slowly. However, if you do not want to take up too much of your disk space, you can always download it in the future from ManualsBase. God bless and be careful. Please read this manual before beginning installation and save this booklet for complete.
For manual operation instructions, see pages 28-31. You can make changes at any time when the thermostat is in Program mode. To utilize the pre-programmed settings, see pages 32-33. May 28, 2011 By describing the wires from your new thermostat and your old one, it sounds like your new thermostat is not compatible with your system. This hunter will not work with multi stage heat pumps. Locate the Auto Recovery thermostat.
Jul 11, 2009 What were each wire connected to on the white rodgers? If you want to quickly view the content of pages found on the following pages of the manual, you can use them. If your old one didn't have letters or you already disconnected it, you will have to go to the furnace. When insufficient battery power is left, the battery icon will flash alone on the display and your system will turn off. See pages 44-45 for more information. Trace them back and connect them appropriately.
This hunter will not work with multi stage heat pumps. Press to change the minute. Which wires should I connect to which terminals on the 44155. Place the top of the thermostat over the two tabs on the wall plate. You will need to get a thermostat for a heat pump. Press until the Hold icon appears.